Vigilancia Tecnológica

In recent years, there is a growing demand for materials that can both improve the mechanical properties of structures and carry out health monitoring and risk warning. In this case, in order to realize distributed deformation monitoring, a new method of making geogrid by 3D printing technology is proposed. The grille rib is made by embedding the conductive polymer (ground carbon fiber as conductive filler) into the insulating shell (PLA material) in the specified path, and then the rib is vertically crossed into each other to form a grille sample. In order to study the distributed deformation monitoring function of this grid, a manual push–pull testing machine was used to conduct a load–unload experiment to analyze the change rule of resistance on the grid plane. The following conclusions were obtained: the closer the ribs are to the load bearing point, the greater the change in resistance, and conversely, the farther the ribs are from the load bearing point, the smaller the change in resistance. Depending on the geogrid network characteristics, the electrical resistance distribution on the geogrid plane can be obtained by superimposing the resistance values of the horizontal and longitudinal ribs, then the location and the magnitude of deformation can be estimated. Additionally, this study carried out numerical simulation of the grid model based on ANSYS 15.0 software and compared with the loading experiment results to verify that the force deformation position can be retrieved through the change of resistance.